The YSE100 series of single axis controllers are designed specifically to enhance your present machine and add capability similar to new programmable machines at a fraction of the cost. Microcomputer based, solid state design and user friendly controls combine for a highly featured controller with long term reliability.
--------------------------------------------------------------------------------
EMBEDDED MICOR
Intel based, 8 bit microcontroller, 64K battery backed RAM for user programmed storage
USER INTERFACE
25 key, keypad for machine configuration, part programming and system control
CONTROL ENCLOSURE
12 gauge steel enclosure, NEMA 12, industrial.
MACHINE INTERFACE
37 pin circular connector with quick connect capability for interface to machine interface cable
CONSOLE FOOTPRINT
The YSE100 console has a 12” L x 9.5” W x 4.5” H profile
POWER SUPPLIES
2, 5VDC supplies; one for controller logic and the other for machine switch isolation
SYSTEM SAFETY FEATURES
Emergency stop button on front panel for complete hydraulic motor and machine shutdown
CONSOLE/MACHINE CABLE
16’ long console to machine controller cable with quick disconnect connectors on both ends for ease of replacement
DETAILED OPERATORS MANUAL
--------------------------------------------------------------------------------
SOFTWARE FEATURES
--------------------------------------------------------------------------------
Part Editing Intuitive part programming using Job Number, Bend Number and Bend Value keys
Machine Configuration Adaptability to different machines and operations using simple Code Functions
Diagnostics Function keys and Setup mode to test machine switches and tooling positions
Run Controls Manual, automatic and setup modes of operation
CLICK ON THE BARS BELOW FOR MORE DETAILS
YSE 100
This single axis controller adapts to most machines that have bend, clamp, pressure die and mandrel hydraulic cylinders. The complete system kit includes the YSE100 controller, a BEI, 900 line industrial grade encoder, an encoder pin and mounting brackets, a controller to machine interface cable, a machine interface cable and an operator’s manual.
YSE 110
The YSE110 controller adapts to machines that have an additional hydraulic cylinder besides the bend, clamp, pressure die and mandrel cylinders. This typically is a deceleration cylinder. The complete system kit includes the YSE110 controller, a BEI, 900 line industrial grade encoder, an encoder pin and mounting brackets, a controller to machine interface cable, a machine interface cable and an operator’s manual.
YSE 100s
The YSE100S is designed to adapt to machines that have sequential hydraulic cylinder control. For these machines only manual and automatic modes of operation apply; there are no individual function controls. The complete system kit includes the YSE100S controller, a BEI, 900 line industrial grade encoder, an encoder pin and mounting brackets, a controller to machine interface cable, a machine interface cable and an operator’s manual
"The Ultimate Goal... To help our customers create the lowest cost
possible without sacrificing quality, value or safety."
Corporate Office • 15333 N. Pima Road, Ste 305 Scottsdale, AZ 85260 • Tel 480.829.0450 • Fax 480.517.6929
Manufacturing Facility • 162 Jack Cooper Drive, Valley Head, AL 35989 • Tel 256.635.6700 • Fax 256.635.6710
© Copyright 2014 - Harco Metal Products, Inc.